1.Identification

1.1 GHS Product identifier

1.2 Other means of identification

1.3 Recommended use of the chemical and restrictions on use

1.4 Supplier's details

1.5 Emergency phone number

2.Hazard identification

2.1 Classification of the substance or mixture

Not classified.

2.2 GHS label elements, including precautionary statements

Pictogram(s)
Signal word	Warning
Hazard statement(s)	H315 Causes skin irritation H319 Causes serious eye irritation H335 May cause respiratory irritation
Precautionary statement(s)
Prevention	none
Response	none
Storage	none
Disposal	none

2.3 Other hazards which do not result in classification

none

3.Composition/information on ingredients

3.1 Substances

4.First-aid measures

4.1 Description of necessary first-aid measures

General advice

Consult a physician. Show this safety data sheet to the doctor in attendance.

If inhaled

Fresh air, rest.

In case of skin contact

Rinse and then wash skin with water and soap.

In case of eye contact

First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.

If swallowed

Never give anything by mouth to an unconscious person. Rinse mouth with water. Consult a physician.

4.2 Most important symptoms/effects, acute and delayed

no data available

4.3 Indication of immediate medical attention and special treatment needed, if necessary

/SRP:/ Immediate first aid: Ensure that adequate decontamination has been carried out. If patient is not breathing, start artificial respiration, preferably with a demand-valve resuscitator, bag-valve-mask device, or pocket mask, as trained. Perform CPR as necessary. Immediately flush contaminated eyes with gently flowing water. Do not induce vomiting. If vomiting occurs, lean patient forward or place on left side (head-down position, if possible) to maintain an open airway and prevent aspiration. Keep patient quiet and maintain normal body temperature. Obtain medical attention. /Organic acids and related compounds/

5.Fire-fighting measures

5.1 Extinguishing media

Suitable extinguishing media

Use water spray, dry chemical, foam or carbon dioxide. Water or foam may cause frothing. Water spray may be used to flush spills away from exposures.

5.2 Specific hazards arising from the chemical

no data available

5.3 Special protective actions for fire-fighters

Wear self-contained breathing apparatus for firefighting if necessary.

6.Accidental release measures

6.1 Personal precautions, protective equipment and emergency procedures

Use personal protective equipment. Avoid dust formation. Avoid breathing vapours, mist or gas. Ensure adequate ventilation. Evacuate personnel to safe areas. Avoid breathing dust. For personal protection see section 8.

6.2 Environmental precautions

Collect leaking and spilled liquid in covered containers as far as possible. Wash away remainder with plenty of water.

6.3 Methods and materials for containment and cleaning up

Cover with soda ash or sodium bicarbonate. Mix and add water. Neutralize and drain into a drain with sufficient water.

7.Handling and storage

7.1 Precautions for safe handling

Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Avoid exposure - obtain special instructions before use.Provide appropriate exhaust ventilation at places where dust is formed. For precautions see section 2.2.

7.2 Conditions for safe storage, including any incompatibilities

Separated from strong bases.Keep containers closed and store in cool and dark places.

8.Exposure controls/personal protection

8.1 Control parameters

Occupational Exposure limit values

no data available

Biological limit values

no data available

8.2 Appropriate engineering controls

Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and at the end of workday.

8.3 Individual protection measures, such as personal protective equipment (PPE)

Eye/face protection

Safety glasses with side-shields conforming to EN166. Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).

Skin protection

Wear impervious clothing. The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace. Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique(without touching glove's outer surface) to avoid skin contact with this product. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Wash and dry hands. The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and the standard EN 374 derived from it.

Respiratory protection

Wear dust mask when handling large quantities.

Thermal hazards

no data available

9.Physical and chemical properties

10.Stability and reactivity

10.1 Reactivity

no data available

10.2 Chemical stability

ON EXPOSURE TO AIR, ESPECIALLY WHEN IMPURE, IT OXIDIZES & ACQUIRES YELLOW TO BROWN COLOR & RANCID ODOR

10.3 Possibility of hazardous reactions

Combustible

10.4 Conditions to avoid

no data available

10.5 Incompatible materials

The improved preparation of 1,4-octadecanolactone involves heating oleic acid (or other C18 acids) with 70% perchloric acid to 115°C. This is considered to be a potentially dangerous method.

10.6 Hazardous decomposition products

When heated to decomposition it emits acrid smoke and irritating fumes.

11.Toxicological information

Acute toxicity

• Oral: LD50 Rat oral 74 g/kg
• Inhalation: no data available
• Dermal: no data available

Skin corrosion/irritation

no data available

Serious eye damage/irritation

no data available

Respiratory or skin sensitization

no data available

Germ cell mutagenicity

no data available

Carcinogenicity

no data available

Reproductive toxicity

no data available

STOT-single exposure

no data available

STOT-repeated exposure

no data available

Aspiration hazard

no data available

12.Ecological information

12.1 Toxicity

• Toxicity to fish: LC50; Species: Pimephales promelas (Fathead minnow, juvenile 4-8 wk, length 1.1-3.1 cm); Conditions: freshwater, static, 18-22°C, dissolved oxygen < or =4.0 mg/L; Concentration: 1000000 ug/L for 1 hr
• Toxicity to daphnia and other aquatic invertebrates: no data available
• Toxicity to algae: no data available
• Toxicity to microorganisms: no data available

12.2 Persistence and degradability

AEROBIC: A 47 and 52 theoretical %BOD for oleic acid (initial concn of 1,000 ppm) was measured over a period of 5 days in screening tests at 20°C using sewage inoculum(1). A biodegradation half-life of 0.66 days was measured for oleic acid at an initial concn of 100 ppm with an aerobic Warburg respirometer at 25°C using activated sludge inocula(2). In another screening study a first order rate constant was measured to be 0.12/hr for oleic acid (initial concn of 100 ppm) which corresponds to a biodegradation half-life of 0.2 days(3). Oleic acid at initial concns of 1, 10, 1, and 10 ppm exhibited 90, 24, 97, and 28 theoretical %BOD, respectively, over incubation periods of 5, 5, 10, and 10 days, respectively, in an aerobic screening study using sewage inoculum(4). A 68 theoretical %BOD (initial concn of 100 ppm) was measured over a period of 5 days in a screening test at 20°C using sewage inoculum(5). A 39 theoretical %BOD for oleic acid (initial concn not given) was measured over a period of 5 days in a screening test at 20°C using sewage inoculum(6). After a 16 day acclimation time, a 63.5 theoretical %BOD was measured for oleic acid (initial concn not given) over a period of 5 days in a screening test at 20°C using activated sludge inocula(7). A 57.2 theoretical %BOD was measured for oleic acid (initial concn of 500 ppm) over a period of 5 days in an aerobic screening test at 20°C using activated sludge inoculum(8).

12.3 Bioaccumulative potential

An estimated BCF of 10 was calculated in fish for oleic acid(SRC), using a log Kow of 7.64(1) and a regression-derived equation(2). According to a classification scheme(3), this BCF suggests the potential for bioconcentration in aquatic organisms is low(SRC).

12.4 Mobility in soil

The Koc of undissociated oleic acid is estimated as 340,000(SRC), using a log Kow of 7.64(1) and a regression-derived equation(2). According to a classification scheme(3), this estimated Koc value suggests that oleic acid is expected to be immobile in soil. The pKa of oleic acid is 5.02(4), indicating that this compound will exist almost entirely in anion form in the environment and anions generally do not adsorb more strongly to soils containing organic carbon and clay than their neutral counterparts(5).

12.5 Other adverse effects

no data available

13.Disposal considerations

13.1 Disposal methods

Product

The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.

Contaminated packaging

Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.

14.Transport information

14.1 UN Number

14.2 UN Proper Shipping Name

14.3 Transport hazard class(es)

14.4 Packing group, if applicable

14.5 Environmental hazards

14.6 Special precautions for user

no data available

14.7 Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code

no data available

15.Regulatory information

15.1 Safety, health and environmental regulations specific for the product in question

16.Other information

Information on revision

Abbreviations and acronyms

• CAS: Chemical Abstracts Service
• ADR: European Agreement concerning the International Carriage of Dangerous Goods by Road
• RID: Regulation concerning the International Carriage of Dangerous Goods by Rail
• IMDG: International Maritime Dangerous Goods
• IATA: International Air Transportation Association
• TWA: Time Weighted Average
• STEL: Short term exposure limit
• LC50: Lethal Concentration 50%
• LD50: Lethal Dose 50%
• EC50: Effective Concentration 50%

References

• IPCS - The International Chemical Safety Cards (ICSC), website: http://www.ilo.org/dyn/icsc/showcard.home
• HSDB - Hazardous Substances Data Bank, website: https://toxnet.nlm.nih.gov/newtoxnet/hsdb.htm
• IARC - International Agency for Research on Cancer, website: http://www.iarc.fr/
• eChemPortal - The Global Portal to Information on Chemical Substances by OECD, website: http://www.echemportal.org/echemportal/index?pageID=0&request_locale=en
• CAMEO Chemicals, website: http://cameochemicals.noaa.gov/search/simple
• ChemIDplus, website: http://chem.sis.nlm.nih.gov/chemidplus/chemidlite.jsp
• ERG - Emergency Response Guidebook by U.S. Department of Transportation, website: http://www.phmsa.dot.gov/hazmat/library/erg
• Germany GESTIS-database on hazard substance, website: http://www.dguv.de/ifa/gestis/gestis-stoffdatenbank/index-2.jsp
• ECHA - European Chemicals Agency, website: https://echa.europa.eu/

Disclaimer: The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. The information in this document is based on the present state of our knowledge and is applicable to the product with regard to appropriate safety precautions. It does not represent any guarantee of the properties of the product. We as supplier shall not be held liable for any damage resulting from handling or from contact with the above product.